FiveTech Software tech support forums

Hello,

Sorry to bring this up again but I am continue to have problems when trying to set the form length. The problem because when I upgraded to FWH 7.11 to 8.01. The problem is that the first form prints properly, however the second form does not feed properly. We have tried to create the same document in MS Word and Acrobat and it works fine so there is a problem with the FWH print system. The printer is an Okidata ML 320, 321 and 490 - all worked properly in version 7.11


Thank you in advance for your help.

Here are two samples.

1)

nWid := ROUND( nWid1 * 254, 0)
nLen := ROUND( nLen1 * 254, 0)
PrnSetSize(nWid, nLen )

PRINT oPrinter FROM USER PREVIEW PRINTER NAME "Grid Utility"

if empty( oPrinter:hDC )
return nil
endif

DEFINE FONT oFont NAME "Arial" SIZE 0,-10 OF oPrinter

if (nLay==1)
oPrinter:SetPortrait()
else
oPrinter:SetLandScape()
endif

PAGE

... Print data ...

ENDPAGE
oPrinter:SetPortrait()
ENDPRINT

nWid := ROUND( 8.5 * 254, 0)
nLen := ROUND( 11 * 254, 0)
PrnSetSize(nWid, nLen )


2)

PRINT oPrinter FROM USER PREVIEW PRINTER NAME "Grid Utility"

if empty( oPrinter:hDC )
return nil
endif

DEFINE FONT oFont NAME "Arial" SIZE 0,-10 OF oPrinter

nPWid := 254 * 8.5
nPHgt := 254 * 12
oPrinter:SetSize(nPWid, nPHgt) // 8.5 x 12 Inches...

if (nLay==1)
oPrinter:SetPortrait()
else
oPrinter:SetLandScape()
endif

PAGE

... Print data ...

ENDPAGE
oPrinter:SetPortrait()

nPWid := 254 * 8.5
nPHgt := 254 * 11
oPrinter:SetSize(nPWid, nPHgt) // 8.5 x 11 Inches...

ENDPRINT

Darrell,

I suggest comparing the printer.prg files from the two versions using a compare utility to see the differences. This should help you isolate the problem.

James

Hello James,

may I ask what utility you use for comparing.
I always use ME then split screen and I go through manually.
Is there a better way?
Thanks in advance
Otto

Otto,

I use WinMerge. It highlights all the differences. Its a great tool.

It is free and can be downloaded here.

http://winmerge.org/

Regards,
James

Otto wrote: may I ask what utility you use for comparing.

I'm using Beyond Compare. It's a commercial product but I'm very satisfied with it.

Thank You, but this seems like a simple part of the application that should work

>Thank You, but this seems like a simple part of the application that should work.

OK. But it seems you are the only one that it is affecting. So, if you want a solution, doing a file compare is probably the fastest solution for you.

Hi James,

Thank you